HP ESL E-series Tape Libraries - Manual (Page 91)

B Relocating the library
CAUTION:
HP strongly recommends that an HP authorized service representative relocate a library to another
location.
This appendix explains how to relocate the library. As used in this appendix, the term relocate means
either to ship the library or simply to move it to a nearby location (for example, from one area in a
building to another).
NOTE:
These instructions address relocating a standalone library. To relocate a Cross Linked (CLM) Library,
you must remove the CLM components including the brackets that connect the cabinets together, and
ensure that you have room for the entire system when selecting a new location. Otherwise, treat the
cabinets as if each were a separate library that you are relocating.
The instructions in this appendix are divided into the following:
• Checking the new installation site
• Preparing the library for relocation
• Crating the library
• Preparing the library for operation
To ship the library or move it using a motor vehicle (for example, truck, or forklift), follow all of the
instructions in this appendix.
To move the library to a new location within the same building or facility, follow all instructions in this
appendix except for those found in Crating the library .
NOTE:
These procedures require the original packing materials of the library. If you do not have the original
packing materials, contact your support representative.
CAUTION:
Moving or shipping the library without proper packing materials can result in damage to library
components.
Checking the new installation site
Check the new installation site for the library using the guidelines found in the HP StorageWorks ESL
E-Series Pre-Installation Site Survey Instructions. Make sure the new location meets all applicable
clearance, environmental, and power requirements.
Preparing the library for relocation
To prepare the library for relocation, refer to:
• Removing tape cartridges
• Installing shipping restraints and packing
HP StorageWorks 91