Switch for the internal network, Tape drives, Cleaning cartridges – HP ESL E-series Tape Libraries User Manual

Page 18: 5 ports on the switch for the internal network

Advertising
background image

Switch for the internal network

CAUTION:

Do not connect this switch to your local LAN. It is for internal library use only. Connecting this switch to

the LAN could cause library components to perform incorrectly or report failures.

The 24-port Ethernet switch provides a private management network to connect the Interface Manager

card to the LTO4 tape drives. You must install one switch in each library that contains LTO4 tape drives.
The ESL library uses a ProCurve Switch 2124. This switch has 24 auto-sensing 10/100Base-TX RJ-45

ports. This switch is a store-and-forward device that offers low latency for high-speed networking.
The switch does not have a power switch; it is powered on when connected to an active AC power

source. The switch automatically adjusts to any voltage between 100-240 volts and either 50 or 60 Hz.

There are no voltage range settings required. The reset button is used to reset the switch while it is

powered on. This action executes the self test, and may clear certain error conditions that have occurred.

11654

1

2

1

Ethernet ports

2

Reset button

Figure 5 Ports on the switch for the internal network

Tape drives

The ESL E-Series tape library can hold up to 24 tape drives. When fewer than 24 drives are installed in

the library, the tape drives must occupy consecutive drive clusters, beginning with drive cluster 0 (see

Figure 2

).

CAUTION:

It is critical to ensure that the media you use matches the format of your tape drive. Cleaning cartridges

and formatted data cartridges are unique for each drive technology. Damage may occur if inappropriate

media is used in tape drives.

Tape cartridges and cleaning cartridges are not included with the library, and must be ordered in

addition to the library.

Cleaning cartridges

NOTE:

By default, Autoclean is disabled. Ensure your application software supports this feature before enabling

it.

If a drive experiences read/write errors when the Autoclean function is enabled, the library issues an

error message stating that drive cleaning is required. Without user intervention, the media picker replaces

18

Library overview

Advertising