Olympus E-20N - Manual (Page 185)

183
12
3
Confirm that the card access lamp
on the camera is off, and then set
the camera power switch to OFF.
4
Disconnect the USB cable.
Note
• To avoid problems, never change the camera’s mode or switch the camera off and on while the
camera is connected to the computer, especially when images are being transferred from the
camera to the computer.
• We recommend using the AC adapter if you operate the camera in the setup/connection mode for
a long period.
• When the AC adapter is not used, before connection confirm that the batteries are fully charged.
Leave the camera connected to the computer only for a short time. The computer could hang up if
the batteries run low while the camera is connected to the computer. The camera will not enter the
sleep mode with the USB cable connected, so the batteries will continue to drain while the camera
remains idle. When you are not using the camera, always switch the camera power switch off.
3 ON
OFF