Olympus E-20N - Manual (Page 23)

21
1
Using the AC adapter (sold separately)
An optional Olympus CAMEDIA-brand AC adapter allows you to power your digital camera from a
common AC wall outlet. Be sure to use the specified AC adapter.
Use an AC adapter designed to operate on the AC voltage in the area the camere is being used.
Consult your nearest Olympus dealer or Service Center for details.
1
Make sure the white line on the
power switch is at the OFF
position.
If the power switch is set to ON, move it to
the OFF position.
2
Make sure that the card access
lamp is off.
3
Plug the AC adapter power cord
into a power outlet.
4
On the lower left side of the
camera, locate the cover with the
mark and open it. Plug the
other end of the AC adapter power
cord into the DC IN jack.
Note
• The AC adapter may become slightly warm
during prolonged use. This is normal and does
not indicate a problem.
Warning
Follow these simple guidelines to ensure safe operation of the camera.
• Use the correct AC adapter
To avoid damaging the camera, personal injury, or other unexpected problems, connect and use
only the AC adapter recommended for use with this camera. Olympus can accept no responsibility
for damage or injury caused by using an AC adapter that is not rated and approved for use with
this camera.
• Use the correct power source
Use only the optional AC adapter intended for use with this camera. Use the AC adapter with this
camera only in the country where you purchased it. The AC adapter is not rated for use with
different power sources, which could vary widely in different countries. Before travelling abroad,
purchase extra batteries. If you have any questions, contact an Olympus authorized service center.
3
ON
OFF 1
4
3
2
DC IN jack
AC adapter power cord plug
Power outlet
AC adapter