Olympus E-20N - Manual (Page 197)

195
Problem Solution Page
Problem Solution Page
Is the built-in flash raised?
Is the subject brightly lit?
Press the flash button to raise the flash
unit.
If there is sufficient incident light, the flash
will not fire. If you must use the flash, use the
fill-in flash mode.
Monitor dark?
Sunlight striking the monitor?
Adjust the monitor brightness.
Use your hand to block the glare from
sunlight so you can see the monitor.
Built-in flash does not fire.
Monitor difficult to see.
Is the cable connected securely?
Something other than lines displayed in the
control panel? Cannot operate the camera?
Check the connection at the camera and
computer and make sure the connections
are tight.
See “Cannot operate the camera, monitor
and control panel blank.”
Cannot transfer data to computer.
Problem Solution Page
➞ 42
➞ 91
➞ 150
➞ 176
➞ 192
Is the USB driver correctly installed? If your operating system is Windows 98/98SE,
install the USB driver following the instructions
in the “Software Installation Guide.”
➞ 176
−