JLG X14JH Operator Manual - Manual (Page 78)

75
and engage on the track‑tensioning wheel. Apply force (6) laterally to allow the track to run
and lift it from the track‑tensioning wheel.
Fitting rubber track
1. Make sure that all the safety conditions are met when the machine is lifted to fit the track.
2. Check that the grease inside the hydraulic cylinder has been removed.
3. Mesh the track links with the sprocket and place the other end of the track on the track
tensioning sprocket.
4. Rotate driving wheel backward (7) pushing the track shoes inside the frame (8).
5. Using a steel tube, position track and rotate driving wheel again.
6. Make sure the track links are properly meshed onto
the sprocket and the track‑tensioning sprocket.
7. Adjust track tension (see paragraph 4.3.2 ‑“Opera‑
tions to loosen/stretch track”).
8. Place rubber crawler on the ground.
4.4 CHECKING BOLTS AND NUTS TIGHTNESS
According to the use of the platform, it is necessary to check all the parts and bolts and nuts
that could become loose.
Pay special attention to the frame parts such as the track tensioning wheels, the translation
gearmotor, the drive wheels and guide rollers. Check them for tightness as per chart beside.
BOOM LIFT MODELS X14JH
JLG
X14JHR0220311
PERICOLO DANGER
8
7
5202 02B H19