Typographical conventions – Labconco Coated Steel, Fiberglass and PVC Blowers 7183200 User Manual
Page 7
3
Product Service 1-800-522-7658, International 816-333-8811
Chapter 1: Introduction
Typographical Conventions
Recognizing the following typographical conventions will help
you understand and use this manual:
Book, chapter, and section titles are shown in italic type (e.g.,
Chapter 3: Getting Started).
Steps required to perform a task are presented in a numbered
format.
Comments located in the margins provide suggestions,
reminders, and references.
Critical information is presented in boldface type in paragraphs
that are preceded by the exclamation icon. Failure to comply
with the information following an exclamation icon may result
in injury to the user or permanent damage to the Blower.
Critical information is presented in boldface type in paragraphs
that are preceded by the wrench icon. Only a trained certifier
or contractor should perform these operations. Failure to
comply with the information following a wrench icon may
result in injury to the user or permanent damage to your
Blower.
Important information is presented in capitalized type in
paragraphs that are preceded by the pointer icon. It is
imperative that the information contained in these paragraphs
be thoroughly read and understood by the user.
A letter icon precedes information that is specific to a
particular blower model. The CS icon indicates the text is
specific to the Coated Steel Blower.
The FRP icon indicates the text is specific to the Fiberglass
Blower.
The PVC icon indicates the text is specific to the PVC Blower.
!
CS
FRP
PVC