Icron Four-Port USB 3-2-1 Raven 3104 Point-to-Point Extender System (328') - Manual (Page 5)

The LEX Unit
The LEX unit connects to the computer using a standard USB 3.2 Gen 1 cable. Power for this unit is provided by the
included 24V 1A adapter.
ITEM TYPE DESCRIPTION
1 Power LED LED is SOLID ON when DC is supplied to the extender unit. LED is OFF when no
power is supplied by the AC Adapter.
2 Mode Reserved for manufacturer use.
3 Config Reserved for manufacturer use.
4 Status LED LED is SOLID ON when system is functioning normally. LED BLINKS when system is
booting OR to indicate a temperature warning in unison with the LINK, USB 2, and
USB 3 LEDs.
5 Link LED LED is SOLID ON when LEX is linked to an opposite REX. LED is OFF when there is
no connection between the LEX and REX units.
6 USB 2 LED LED is SOLID ON when an active USB 2 connection is established through the
extender system. LED BLINKS when the USB 2 connection is suspended/asleep.
LED is OFF when no USB 2 connection is detected.
7 USB 3 LED LED is SOLID ON when an active USB 3 connection is established through the
extender system. LED BLINKS when the USB 3 connection is suspended/asleep.
LED is OFF when no USB 3 connection is detected.
8 LAN Port
(100/1000Mbps)
Ethernet pass through channel connects to a network or Ethernet device.
9 Link Port (RJ45) Accepts RJ45 connector for CAT 6a/7 cabling to connect the LEX to the REX.
10 USB Host Port USB 3 Type B receptacle used to connect LEX to USB 3 Host computer.
11 DC Power Port Locking connector for the included power adapter – accepts 24VDC 1A.
4
Front View
Rear View
Config
USB 2 USB 3 Mode Power Link Status
3 1 2 4 5 6 7
LAN 24V 1A USB
Link
8 9 10 11