LEICA M11 Monochrom Rangefinder Camera - Manual (Page 13)

GENERAL INFORMATION 13
battery is depleted, it must be replenished by inserting a charged
main battery. The time and date will have to be set again after a
full depletion of both batteries.
• As the battery capacity deteriorates or if using an older battery,
warning messages may appear and some functions may be re-
stricted or blocked entirely.
• Always remove the battery if the camera will not be used for an
extended period of time. Make sure to switch the camera off via
the main switch before removing the battery. Leaving the battery
in the camera will result in a deep discharge after a few weeks.
Voltage levels will decrease significantly, as the camera uses a low
idle current to maintain settings.
• Dispose of damaged batteries in accordance with the relevant
regulations at an approved collection point for proper recycling.
• The date of manufacture can be found on the battery. The date
format is week/year.
MEMORY CARD
• The range of available SD/SDHC/SDXC cards on the market is too
extensive for Leica Camera AG to test for compatibility and qual-
ity. Generally, any type of memory card may be used without any
damage to the camera or memory card. As some “no name” cards
may not fully comply with the SD/SDHC/SDXC standards, Leica
Camera AG cannot provide any guarantee of function.
• We recommend formatting memory cards from time to time, as
fragmented residual data from deleted files may block some of the
storage capacity.
• Generally, it is not necessary to format (initialize) memory cards
that have been previously used. Formatting will, however, be
necessary if you insert an unformatted memory card or a card
that was formatted in another device (e.g. a computer) for the first
time.
• We recommend backing up your data on a PC, because electro-
magnetic fields, static electricity and any damage to the memory
card or camera defects may result in irretrievable damage or loss
of your data.
• SD, SDHC, and SDXC memory cards come with a write protection
slider to prevent accidental overwriting. This slider is located on
the non-beveled side of the card. All data on the card is protected
when the slider is set to its lower position, marked LOCK.
• All data stored on the memory card will be lost during formatting.
Formatting will not be prevented by a deletion protection set for
individual shots.
SENSOR
• Any dust or dirt particles stuck to the glass cover of the sensor
may result in noticeable dark stains or specks on the images (in
system cameras). Alternatively, send your camera to the Leica
Customer Care department for sensor cleaning (see p. 184). This
service is not part of the warranty offering and will therefore incur
charges.
DATA
• All data, including personal information, may be changed or deleted
due to incorrect or accidental operation, static discharge, acci-
dents, malfunctions, repairs and other measures.
• Please note that Leica Camera AG does NOT accept liability for
direct or consequential damage due to the manipulation or destruc-
tion of data and personal information.