Xerox 701P21091 - Manual (Page 132)

Specifying input parameters
2-24 Using LCDS Print Description Language
DBCODE DEFAULT
Specifies a base code from which you can make double-byte
character code assignment exceptions.
The base code is specified by a codetype; the exceptions are
specified in the ASSIGN parameter.
Syntax ac: DBCODE DEFAULT = codetype
Options
Default No default
DBCODE command: point to note
The KCODE command can be used in the same manner as
DBCODE. DBCODE is the preferred usage.
IDEN command
Invokes dynamic job descriptor entry (DJDE) processing.
The IDEN command coded in the JSL notifies the system that
DJDE records may be part of the input data stream. IDEN also
describes the characteristics or search criteria for locating and
identifying DJDE records.
The DJDE record(s) are interspersed among the data records in
the input data stream. Each DJDE record contains an
identification field (which matches the search criteria specified in
the active job) and a series of parameters that describe the
actual JDL changes to be applied to the job.
The following sections describe the syntax of the IDEN
command parameters and explain their options.
Table 2-21. DBCODE DEFAULT parameter options and definitions
Option Definition
codetype Keyword for one the following double-byte codes:
•
IBM: Specifies the IBM Nihongo character set (Kanji double-byte sets)
• JEF: Specifies the Fujitsu JEF Kanji double-byte character set.
• JIS
• KEIS: Specifies the Hitachi KEIS Kanji double-byte character set