EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 38)

Issue
11.00.C
Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
28
By pressing the D key ( - - - > ), the operator has access to the D, E and F cameras. The
operation menu becomes:
Rst Cam Local Sync Prv 2nd CTRL
Cam D Cam E Cam F <---
Press the D key ( < - - - ) to return to CAM A, B, C selection.
Rst Cam
This function restores the position of cameras on the active channels: CAM A on PGM1,
CAM B on PRV.
Note
When a clip/playlist is loaded on a channel, switching back to Live mode will
recall the record train, which was last used on that output. This avoids too
frequent uses of the RST CAM function.
Local
This function allows the user to reconnect to the local LSM after having accessed distant
clips or record trains. The function is highlighted when the user is connected to both clips
and record trains on the local LSM. It is displayed only on Master/Server LSMs when they
are connected to the SDTI network.
Sync Prv
This option allows the user to synchronize the PRV with the timecode and speed of the
PGM output. This function is not available with remote record trains.
2nd CTRL
This function allows the operator to swap the control of one or several play channels
between the EVS Remote Panel and a third-party controller. Both controllers receive
permanently the status of the channel(s), but only one controller at a time is able to
actually control a channel. The secondary controllers are defined in page T2.2 of the
Technical Setup menu.