Toggle / all, How to assign a camera to a channel – EVS MulticamLSM Version 11.00 Operating Manual User Manual
Page 42
Issue
11.00.C
Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
32
Note
The 1PGM mode is a simplified version of the 2 or 3PGM modes. The
operational menu has less functions:
Local
2nd CTRL
Cam A
Cam B
Cam C
Cam D
Also, the user does not need to select a channel to enable or disable the
secondary controller. Since there is only 1 channel available in this mode, the
operator just has to press
SHIFT+D to swap the control between the secondary
controller and the EVS remote.
Toggle / All
The
Toggle function is only available in 3PGM mode:
•
Toggle OFF: Selecting an output channel results in controlling that channel and
disables the control on others.
•
Toggle ON: Selecting a channel will alternatively enable/disable the control over that
channel without changing the control on the others.
•
All: This enables the control on all channels.
How to Assign a Camera to a Channel
In Multi PGM mode, to change the current camera on each PGM, proceed as follows:
7. In the operational menu, select the PGM to which you want to change the current
camera.
The
TAKE key at the bottom of the remote is lighting red.
8. Press the
TAKE key.
It lights green and the menu on the LCD display changes to let you select the desired
camera.
Rst Cam
Local
CAM A
CAM B
CAM C
CAM D
9. Press the camera you want to associate to the selected PGM.
10. Press
TAKE again to return to the PGM selection menu.