EVS XT3 Version 11.00 Configuration Manual - Manual (Page 92)

Mix on One Channel Settings
Introduction
The Mix on One Channel settings allow specifying whether the secondary link of the
codec module (J3) of the play channel will be used to provide mixing with a single codec
module.
These fields are available in the following interfaces:
• in the Multicam Configuration window, Channels tab, in the advanced display mode:
◦
on page 5, 6 or 7 on the server-based application.
◦ on page 1 on the web-based interface.
• in the Technical menu of the Remote Control Panel (T2.9).
Warning
The Mix on one channel settings are only available if the license codes 31 is
valid.
The following screenshot presents page 7 of the Channels tab, where the Mix on One
Channel settings are available in the server-based application, and highlights the Channel
and Control settings area:
Mix on one channel
Description Enables/disables mixing on a single codec module, by means
of the secondary link of the codec module (J3) of a play
channel. This function applies to mixes in playlists, not in
timelines.
The license code 31 is required for the Mix on One Channel
feature to be available.
Mix on One Channel is available for all controllers (LSM
Remote panel or protocol), and with all codecs and resolutions,
except in 1080p and AVC-intra.
Values Yes / No (default)
XT3 Server - Version 11.00 - Configuration Manual
3. Multicam Configuration 86