B&B Electronics APXN-Q5428 - Quick Start Guide - Manual

First, check your LEDs.
Then use your smart
phone to access complete
documentation on our web
site. Simply scan the code
to the right or visit the
B&B Electronics Knowledge
Base:
http://support.bb-elec.com/knowledgec.aspx
APXx-Q5xxx
CD with Airborne Management Center
software
5-36 VDC power for terminal block
or a 5 VDC Power Supply (not included)
50 ohm, omni-directional antenna
http://www.bb-elec.com/Products/
Power-Supplies-Accessories/Serial-
Cables.aspx
Document number – PN710-00048-00_R000_APXx-Q5xxx_1413qsg
© 2013 B&B Electronics Manufacturing Company
1-888-948-2248 | Europe: +353 91 792444
www.bb-elec.com
Recommended Accessories
and Power Supplies
707 Dayton Road | PO Box 1040 | Ottawa, IL 61350
Phone: 815-433-5100 | Fax: 815-433-5109
www.bb-elec.com | E-mail: [email protected]
Fast and easy on the web: www.bb-elec.com
First Things First...
Before you begin, be sure you have
the following:
Wireless Access Point
APXx-Q5xxx
Fast, Easy Answers
Use the Help features of the interface to help you
configure the device. When you have finished
configuring the device, press ‘Commit’ to save the
changes, then ‘Restart’ to restart the device. You
can optionally press ‘Reload’ if you have further
configuration changes to make.
LED Airborne Device State
POWER
Adapter is not powered.
Adapter is powered
POST
Adapter is not powered.
Adapter failed Power On Self Test (POST)
Adapter passed POST but is not configured for wireless
network communication.
Adapter passed post and is configured for wireless com-
munication.
LINK
Adapter is not powered or the wireless radio is OFF
Adapter is powered and the wireless radio is ON
COMM
If Power LED is also Off then Adapter is not powered.
If Power LED is On then: No TCP session from WLAN or
Ethernet interface has been established.
A TCP connection to the adapter has been established from
the wireless interface and no Ethernet link has been detected.
A TCP connection to the adapter has been established from
the Wireless or Ethernet interfaces but no traffic has been
detected.
If your device is connected and configured correctly, you
will see the following LED Status:
COMM: RED
LINK: GREEN
POST: GREEN
POWER: BLUE
7 Check Your Setup
8 Troubleshooting
PS-SDS
120VAC/5VDC Power Supply
http://www.bb-elec.com/Products/
Power-Supplies-Accessories/Wall-
Transformer-Power-Supplies/Power-
Supplies.aspx
Continuing Section 6
Serial Cables