Teledyne LeCroy Summit T3-16 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 32)

Teledyne LeCroy Using Probes
20 Summit T3‐16 PCI Express Multi‐Lane Protocol Analyzer User Manual
Figure 3.15: Half-size Gen2 Mid-bus Probe Cable and Header Assembly
Figure 3.16: 1 or 2 Clock Cable
Connections Overview for Gen2 MidBus Probe
Use a 1‐pod or 2‐pod setup depending on the lane width of the recording:
 For x16 recordings, use the 2‐pod setup.
 For all other lane width recordings, use a one‐pod setup.
Use the iPass Y‐cables to connect the probe data connectors on the Analyzer to the
MidBus pod(s).
On the other side of the pod, connect the MidBus probe assembly (see Figure 3.17 on
page 21 ).