Lincoln Electric IM8002 POWER WAVE MANAGER User Manual
Page 21
![background image](/manuals/363582/21/background.png)
Update Welding Power Source Firmware
Chapter 3. Installing Power Wave® Manager
IM8002
Power Wave® Manager User Manual
3.3
Procedure
Details
the Troubleshooting section (Appendix A).
7.
Click the Connect button once you have
entered the IP address for the power source
you are updating.
The software scans the Welding Power Source to
verify if the firmware currently on the machine
is up to date.
TIP |
You can also see this information under
System Status > Module Information > Software
Version in Power Wave® Manager. See Figure
8.
If the firmware is not up to date, you must click
Continue to update the Welding Power Source.
The system proceeds with the update.
If the firmware is already up to date, you will
receive the message Update not required and
you can click Exit to close the window.
9.
Exit the program once the firmware has
finished updating.
10.
Repeat steps 4 through 9 for each power source
you need to update.