Lincoln Electric IM8002 POWER WAVE MANAGER - Manual (Page 35)

IM8002 Power Wave® Manager User Manual 6.1
Chapter 6
Power Source Settings
The Power source settings section consists of various subsections that contain settings for the Welding
Power Source component of the welding system. You will access the Power Source Settings when you first
set up your Welding Power Source, but once you have your Welding Power Sources set up and welding, you
will use this section infrequently. You may need to recalibrate the machine over time or as processes
change.
Calibration
The Calibration section allows you to calibrate the Welding Power Source by adjusting the amperage and
voltage outputs so that they match setpoint values. You can also use this function to activate the Welding
Power Source output for other troubleshooting purposes. To change the amperage setpoint, you can click
the up or down arrows ( ) next to the Amperage setpoint field or type the specific value directly in the
field.
Figure 6.1 Calibration
STOP | Buttons on this tab control the output of the
Welding Power Source. Be sure to exercise all
appropriate safety procedures when
performing actions on this tab. Be careful that
the Welding Power Source is not currently
welding before calibrating.