Network settings, Communication status, Chapter 7 network settings – Lincoln Electric IM8002 POWER WAVE MANAGER User Manual
Page 43
IM8002
Power Wave® Manager User Manual
7.1
Chapter 7
Network Settings
The Network settings section provides you with the flexibility to configure the connection of the Welding
Power Source to other equipment. You can connect various components through the use of ArcLink
technology, DeviceNet communications, and/or Ethernet connections. The Network settings section allows
you to review and monitor these settings.
Communication Status
Under Communication status, Power Wave® Manager displays an active graph and provides you with the
real-time communication status of the various components connected to this Welding Power Source. This
section is useful for identifying problems or errors in communication. Use the checkboxes at the bottom of
the graphs to add or remove graphs from your displays.
NOTE |
The graphs displayed for you depend on the hardware
connected to and supported by the Welding Power Source.
TIP
|
“Tx” means “transmitted” and “Rx” means “received”.
Figure 7.1 Connection Status