Ag Leader GPS 2100 Operators Manual - Manual (Page 65)

GPS 2000/2100 Installation
Ag Leader Technology
April 1998 7-3
Follow these steps to rout the cable to the cab:
Step Action
1 Find a place on the right side or bottom of the cab to rout the coaxial
cable into the cab (the point of entry is up to you).
Note: Do not rout the cable through a door or window because this
could crimp the cable and ruin it.
2 Find a site to drill where you will not drill into any cabling or hoses,
then drill a hole with a 1/2-inch bit.
Note: Make sure before you drill that:
•
The coaxial cable will reach to the site you have chosen.
•
That you do not bend the cable at a 90-degree angle.
Step Action
3 Thread the bulkhead connector through the hole, so that the threaded
end to which you attach the lock washer and jam nut is inside the
cab.
Note: For JD 9000 series combines, a rubber grommet is included
to mount the bulkhead connector through the cab wall plate. Use the
auxiliary hole in the plate or drill a new hole in the plate if the
auxiliary hole is in use.
4 Attach the coaxial cable from the antenna to the outside end of the
connector.
Installing the GPS
2000/2100 in the
Cab You will need the following parts and tools to install the GPS 2000/2100 in
the combine cab:
•
GPS 2000/2100 unit
•
GPS2000/2100 to YM2000/2100 adapter cable
•
10-foot coaxial cable
•
Cable installation kit
Follow these steps to install the GPS 2000/2100 in the cab:
Step Action
1 Attach the 10-foot coaxial cable to the end of the bulkhead
connector inside the cab.
2 Find a position to mount the GPS 2000/2100 unit.
Important: Mount the unit so that it does not vibrate or move