AJA FS2 - Manual (Page 118)

118
8.0 Audio
Output Phase This parameter enables or disables individual audio phase adjustment of the 16
audio output channels. When Adjust is selected, parameters 8.1 through 8.16 are
then used to adjust phase for the 16 channels.
Note: If parameter 3 Audio Follow Video is set to On, the Audio Output Phase
selection is independently kept for each video input. If Audio Follow Video is set to
Off, a single Audio Delay value applies, regardless of the video input. (This value is
independent of any of the values used in Audio-Follow-Video mode.)
8.1–8.16 Audio
Phase Ch1–16 These parameters select whether audio phase is normal (same as passed from the
input) or inverted on Channels 1–16.
If parameter 3 Audio Follow Video is set to On, then Audio Output Phase selection is
independently kept for each video input. If Audio Follow Video is set to Off, then the
last setting you made for Audio Output Phase is used.
8.0 Audio Output Phase Selections Selection Descriptions
Unity (default)
Adjust
Disable audio phase adjustments and set phase to unity.
Enable audio phase adjustments for the 16 audio channels.
8.1-16 Audio Phase Ch1–
Ch16
Selections Selection Descriptions
Normal (default)
Invert
Phase is unaltered as it passes from the input to the output.
Phase is inverted as it passes from the input to output. (This may be useful
to correct analog audio signals that are incorrectly wired, placing audio
out of phase at input.)