Bio-Rad Bio-Plex Manager™ MP Software Upgrade - Manual (Page 34)

3 | Running Protocols
32 | Bio-Plex Manager MP Software
Once the reading for a well is complete, the pulsing triangle resolves into one of the
following symbols indicating the result of the reading.
Symbol Description
The bead count for all analytes is
20 or higher.
The bead count for one or more
analytes is below 20 bead
events.
No data were found or an error
occurred while reading the well.
The results are displayed in the Raw Data table and the Bead Map.
Raw Data Table
As the wells are read, the Raw Data table is populated with the results. The table
displays the well location and the well type for all formatted wells. As
Bio-Plex Manager MP completes reading each well, the Raw Data table is
populated with the results for that well. The fluorescence intensities of the analytes
you selected are displayed for each well.
Note: During a reading, the array reader detects all of the analytes in the
sample, including any that you have not selected. However, any analytes that
are not selected in the protocol are not included in the table, even if they are
detected. After a reading you can edit the protocol and change the selection of