Hasyncstart – Dell POWEREDGE M1000E User Manual
Page 423
Fabric OS Command Reference
391
53-1001764-02
haSyncStart
2
haSyncStart
Enables High Availability state synchronization.
Synopsis
hasyncstart
Description
Use this command to enable the High Availability (HA) state synchronization.
After issuing hasyncStop, the switch does not go back to sync start unless you reboot the active CP,
or reboot the standby CP, or issue hasyncStart. The time it takes for the HA sync to complete
depends on the system configuration. The HA sync timeout is set to 10 minutes.
Note
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, “Using Fabric OS commands” and Appendix A, “Command
Availability” for details.
Examples
To enable the HA state synchronization:
switch:admin>
hasyncstart
See Also
haFailover, haShow, haSyncStop