Dell PowerVault TL1000 User Manual
Page 63
2.
Link speed (Default: Auto Negotiation)
a.
Select Configure Network Settings > Configure Link Speed.
b.
Select the required speed and press Enter.
c.
Press Enter again to apply the setting, or Cancel to reject the setting.
The speed must be set to Set Auto Negotiation for gigabit Ethernet
networks.
d.
Press Cancel to backtrack through the menu hierarchy.
3.
DHCP IPv4 (Default: Enabled)
a.
Select Configure Network Settings > Configure DHCP > Configure
DHCPIPv4
.
b.
Select Enable DHCP IPv4 and press Enter to enable, or press Down and
select Disable DHCP IPv4 to disable.
c.
Press Enter again to apply the setting, or Cancel to reject the setting.
d.
Press Cancel to backtrack through the menu hierarchy.
4.
DHCP IPv6 (Default: Disabled)
a.
Select Configure Network Settings > Configure DHCP > Configure
DHCPIPv6
.
b.
Select Enable DHCP IPv6 and press Enter to enable, or press Down and
select Disable DHCP IPv6 to disable.
c.
Press Enter again to apply the setting, or Cancel to reject the setting.
d.
Press Cancel to backtrack through the menu hierarchy.
5.
IPv4/IPv6 Address (Default: 0.0.0.0). If DHCP is disabled, set the IP address
manually.
a.
Select Configure Network Settings > Change IP Address.
b.
Select Set IP Address IPv4 to enter the IPv4 address of the tape library.
Set IP Address IPv6
to enter the IPv6 IP address (split over 4 screens).
c.
Press Enter again to apply the setting, or Cancel to reject the setting.
d.
Press Cancel to backtrack through the menu hierarchy.
6.
IPv4 Subnet Mask (Default: 255.255.255.0). If DHCP IPv4 is disabled, set the
IPv4 subnet mask manually.
a.
Select Configure Network Settings > Change Subnet Mask > Set Subnet
Mask
.
b.
Enter the IPv4 subnet mask.
c.
Press Enter again to apply the setting, or Cancel to reject the setting.
d.
Press Cancel to backtrack through the menu hierarchy.
7.
IPv6 Prefix Length (Default: 64). If DHCP IPv6 is disabled, set the IPv6 prefix
length manually.
a.
Select Configure Network Settings > Change Subnet Mask > Set Prefix
Length
.
b.
Enter the IPv4 prefix length.
c.
Press Enter again to apply the setting, or Cancel to reject the setting.
d.
Press Cancel to backtrack through the menu hierarchy.
8.
IPv4/IPv6 Gateway (Default: 0.0.0.0). If DHCP is disabled, set the IP address
manually.
a.
Select Configure Network Settings > Change Gateway.
b.
Select Set Gateway Address IPv4 to enter the IPv4 gateway address or Set
Gateway Address IPv6
to enter the IPv6 gateway address (split over 4
screens).
Chapter 3. Installation and configuration
3-25