KEYENCE LS-7000 - Manual (Page 46)

3-2
Chapter 3 Operation Control
3
Selection of Measured Value Display
Displayed values on the main and sub displays can be switched. The main display can
display the measured results of OUT1 (or OUT2) and the sub display can display tolerance
comparator set values or measured values simultaneously. Four display types can be
selected in two tolerance modes (i.e., the reference value mode and threshold mode).
Refer to Option settings on page 4-54 for the selection of the reference value mode or
threshold mode.
Press the DISP (display) key and select
the value or item.
The following displayed values can be
selected.
AREA DISP
HOLD
ZERO
■ Tolerance Mode with Reference Value
TIM
LO
GO
HI
OUT 2
OUT 1
FOCUS
2
1
A R E A POSITION
HI
GO
LO
TIM
LO
GO HI
OUT 2
OUT 1
FOCUS
2 1
A R E A POSITION
HI
GO
LO
TIM
LO
GO
HI
OUT 2
OUT 1
FOCUS
2
1 A R E A POSITION
HI
GO
LO
TIM
LO
GO
HI
OUT 2
OUT 1
FOCUS
2 1
A R E A POSITION
HI
GO
LO
OUT1 is lit.
OUT2 is lit.
OUT1 is lit.
OUT2 is lit.
OUT1 measured value is displayed.
OUT2 measured value is displayed.
OUT1 measured value is displayed.
OUT2 measured value is displayed.
OUT1 upper limit is displayed.
OUT2 upper limit is displayed.
OUT1 reference value is displayed.
OUT1 measured value is displayed.
OUT2 measured value is displayed.
OUT2 reference value is displayed.
OUT1 lower limit is displayed.
OUT2 lower limit is displayed.
DISP DISP
DISP DISP
DISP DISP