KEYENCE LS-7000 - Manual (Page 95)

4-43
Chapter 4 Function Settings
4
4
Press the
ENT
key.
The input item is entered and the output setting display appears again.
Offset
An offset value is a desired value that can be added to or subtracted from measured
values. If the offset value is set, it is possible to display the offset value immediately on the
screen by using the auto zero function.
Setting Range
The range can be set between –99.99999 and 99.99999 mm. This range varies with the
display unit or minimum display unit setting. Refer to Display Unit on page 4-57 and
Minimum Display Unit on page 4-58.
Input positive or negative values to increase or decrease the set value.
1
Press the
ENT
key when the output
setting is displayed.
2
Press the
FUNC
key three times.
HI
GO
LO
3
Press the or key and set the offset value.
PROG No.
PRINT
AREA DISP
ESC G
C ENT
HOLD
ZERO
FOCUS
A POSITION
HI
GO
LO
Press these keys
to set the value.
The selectable
part flashes.
Press this key to set the value
to a positive or negative one.
4
Press the
ENT
key.
The input item is entered and the output setting display appears again.
■ Master Calibration with Automatic Zero (Automatic Offset) Function
The automatic zero function sets measured values to the preset size values (i.e., offset
values) of master workpieces. Refer to Measurement of Outer Diameter and Width (with
Two Measuring Heads for Larger Objects) on page 2-4 for an application example. For
the details of the automatic zero function, refer to Automatic Zero Function on page 3-6.