EVCO EVB1256N9D - Manual (Page 25)

EVCO S.p.A. EVBOX1 | Installation guide ver. 1.3 | Code 144BOX1E134
page 25 of 92
6 USER INTERFACE
6.1 Preliminary notes
Operating Statuses:
- “on” state (the device is powered and is on: the
regulators can be switched on)
- “stand-by” status (the device is powered but is
switched off via software: the regulators are
switched off; the possibility to turn the room light
or the auxiliary output on/off manually depends on
parameter u2)
- the “off” status (the device is not powered).
Hereafter, with the word “start-up” means the passage from
“stand-by” status to “on” status; the word “shutdown” means
the passage from “on” status to “stand-by” status.
When the power is switched back on, the device displays the
status that it was in at the time it was disconnected.
6.2 Device switch-on/off in manual
mode
To turn the device on/off in manual mode, proceed as follows:
1. Make sure that the keyboard is not locked and that
no procedure is in progress.
2. Hold the key “ON/STAND-BY” for 2 s.
Using the digital inputs it is also possible to remotely switch
on/off the device.
6.3 The display
If the device is switched on, during normal operation, the
display will show the magnitude established with P5, except
during defrosting, when the device will show the temperature
established with parameter d6.
If the device is switched off, the display will be switched off.
6.4 Displaying the magnitude
detected by an analogue input
To display the magnitude detected by an analogue input,
proceed as follows:
1. Make sure that the keyboard is not locked and that
no procedure is in progress.
2. Hold the key “DOWN” for 1 s: the display will show
the first label available.
3. Press and release the key “UP” or “DOWN” to
select a label.
Device switch-on/off in manual mode
Access the procedure to display the quantity detected by an analogue
input