Interlogix Monitor XL Advanced Installation Guide - Manual (Page 64)

58 Monitor xL™ Advanced Installation Guide 21-3602E rev1.5
Z001 - Z003 (Shared User Data)
Allows Users, Authority Levels and Holidays to be shared across multiple accounts using Director version 4.2.
With Director V4.2, this feature is limited to panel feature-set 2, 3, and 4 (1 panel per account, max. 1000 users,
etc.). Information for this type of system set-up is available in the v4.2 Director’s User Guide.
Shared Users, Authority Levels and Holidays are considered to be under Director control and not panel control.
Programming for this selection is not done in the LCD keypad configuration screens. Programming is only done
for these selections with the use of the Director software and sent to the panel.
Initiating a “Get from Panel” from the Director software cannot be done for the following reasons:
Shared Users and Holidays

If changes for these selections have been made at the panel using an LCD keypad and a Get from Panel is done
at the Director software, the new information in the panel will be ignored and overwritten with the server’s old
information.
Shared Authority Levels
 Shared Authority Levels that are not in the panel, will have any new information that has been entered into the
server data base for their Areas and Schedules cleared.
Panels with Firmware Earlier than v4.2 and a Get from Panel is Done:
1. If a Shared User has been edited at the panel, only their PIN will be updated. The server will replace any of the
other user’s data with the server’s old information.
2. If a Shared Authority Level is deleted at the panel, any new and valid information for the Authority Level’s Areas
and Schedules will be cleared at the server and the panel.
Keypad Operations at Panels with v4.2 Firmware
1. Only a Shared User’s PIN can be edited at the panel and only by that Shared User.
Shared Authority Levels cannot be deleted at the panel.
Premises IP Module HSC-IP Receiver Communications
Programming Sections
Program Section: N001 (Network)
Program Section: J001 (HSC-IP Communications)
Program Section: K001 (HSC-IP Communications with MONITOR ISM/xL)
Refer to Installation Instructions 21-3691E for these programming selections.