Figure 4.11 selection box for speed mode – LINK Systems OmniLink II Press Automation Control User Manual

Page 64

Advertising

August 30, 2002 Manual Version 1.0

4.15

Figure 4.10 Speed/Load Configuration Menu

Section 4.2.2.1 Setting Speed Mode

If you have the optional Analog Input/Output board, the Speed Mode setting at the top of the menu
is the first setting you will make. If your press is a fixed speed press, leave the Speed Mode setting at
the top as “Not Used”. The only use of the Analog Input/Output board will be to allow Percent Motor
Load to be displayed, and the only setting you will make on this menu is for “Percent Load Cal #”. If
your press has a variable speed drive, three Speed Mode choices that make use of the Analog
Input/Output board are possible. Pressing the CHANGE SETTING softkey with the Speed Mode
setting highlighted will cause a selection box to appear as shown in Figure 4.11.

Figure 4.11 Selection Box for Speed Mode

Stroke

Mode

Drive

Speed
Stroke
Speed

SPM

0
0

Order

Counter

SYSTEM STATUS

Counter OFF

Speed/Load
Config

CHANGE
SETTING

EXIT

Speed Mode:

Maximum Input SPM :

SPM Input Offset :

SPM Input Cal # :

Percent Load Cal # :

Minimum Output SPM :

Minimum Output Cal # :

Mid Range Output SPM :

Mid Range Output Cal # :

Maximum Output SPM :

Prod. Mode Min SPM :

Setup Mode Fixed SPM :

Motor Speed Reading (SPM) :

Percent Load Reading :

MOTOR
SPEED

Not Used

Calibration Parameters

Speed Parameters

Speed and Load Readings

0
0

ENTER
CAL. MODE