LINK Systems OmniLink II Press Automation Control User Manual
Page 78
August 30, 2002 Manual Version 1.0
4.29
4. Those settings and operations that the system always requires Key/Code access to Program Mode to
make.
Section 4.2.4.3.1 Choosing Access Mode
Access configuration begins with choosing Access Mode on the Access Configuration screen shown in
Figure 4.15. This screen appears when the ACCESS CONFIG softkey on the Top Display Area
Configuration screen of Figure 4.13 is pressed.
Figure 4.15 Access Configuration Screen
There are four access modes available for those settings and actions that are restricted to Key/Code
access. These are Key and Code, Code Only, Key or Code, and Key Only. These modes are explained
in Section 3.9. The access mode selected applies to all users. Note! If Key Only access mode is
chosen, you will not have to perform the calibration steps related to Access Timeout or user
descriptions and codes that are described in the following sections. You will need to choose to
choose to restrict or unrestrict the certain actions as described in Section 4.2.3.4.1.
To change the access mode position the cursor on the current access mode setting, press the CHANGE
SETTING softkey, position the cursor to the desired access mode, and press the ENT key.
Section 4.2.4.3.2 Settings and Actions That Can Be Restricted to Program Mode Only or are
Available in Both Run and Program Modes
Regardless of which access mode is chosen in the previous section, there are a few commonly
performed actions and settings that the system allows the user to choose to be restricted to Program
Mode only or to be done in Run Mode screens as well as Program mode. To configure whether these
items are restricted to program mode or not, press the RESTRICT/UNRESTRICT ACTIONS softkey on
1
2
3
4
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
0
0
Order
Counter
PC STATUS
Counter OFF
ACCESS
CONFIG
EXIT
0
0
Program/Run Switch
TOP
CHANGE
SETTING
CHANGE
NUMBER
Access Mode:
“Key and Code”
requires access
code and
RUN/PROG Key
for any
changes. “Code
Only” requires
access code and
ignores
RUN/PROG Key.
“Key or Code”
requires an
access code or
the RUN/PROG
Key but not
both. “Key
Only” requires
RUN/PROG Key
and does not
use access code.
HELP
ACCESS CODE CONFIGURATION
Access Mode:
Access Timeout:
Access Timeout:
Key Only
20 Seconds
10 Strokes
User Description
Used
Operator Level # 1
Yes
Operator Level # 2
Yes
Setup
Yes
No
No
No
No
No
No
No
No
No
No
No
No
No
EDIT
USER
SET
CONFIG.
CODE
RESTRICT/
UNRESTRICT
ACTIONS