CIRCUTOR PowerStudio Series - Manual (Page 152)

PowerStudio PowerStudio
152 User Manual
Only in control by level. Value of the demand at which the alarm is
triggered.
Only in control by level. The desired difference between the
connection and disconnection point of the relay is entered in %. The value must be between 4 and 50
%.
Only in control by level. Time elapsed from end of alarm situation
until relay is connected.
Only in control by level. Time elapsed from when the alarm value is
exceeded until the relay is disconnected.
Only in control by level. Specifies whether or not the alarm will remain locked after it
has been triggered, even though the condition that caused it disappears.
Only in control by level. It will only be possible to choose between the two
status modes of the contract for each of the relays.
1.39.1.2 Inputs
Only for DH-96 CT devices.
This screen lets the flow and counter variable that can be used on the DH-96 CT equipment be
configured.
• Counter Variable
o Description: Alphanumeric type data which allows a brief description of the input for
better identification.
o Unit: Alphanumeric type data which enables a brief description of the input units to be
entered.
o Factor: Multiplier factor to be applied to the value read from the device.