Gasboy 03908X - Manual (Page 24)

Installation
Page 24 MDE-4351A Gasboy ATC Kits 039086 and 039087 Installation Manual • February 2006
38 Connect the other end (connector) of the probe to probe connector assembly in the connector
labeled “1”.
39 Locate the other two plugs in the hydraulic coupling toward the left side of the unit ( Figure
21 ).
40 Repeat Steps 29 through 34 to mount the second probe assembly.
41 Connect the connector end of the second probe to probe connector assembly in the connector
labeled “2”.
42 Go to “Completing Installation” on page 24 in this manual.
Completing Installation
1 Dress the cabling by placing them in existing cable ties. Be sure the cables do not create any
obstruction to operation, access or servicing.
2 Test the ATCs to determine that they are functioning properly.
This will involve running transactions and using the totalizer display (see
Appendix: Totalizer
Display Information ).
3 After determining that the ATCs are functioning properly, remount the doors on both sides of
the unit and secure with the keylocks.
4 Inform the manager/owner that the unit can be returned to service.