Gasboy CFN Series SCII Start-Up Manual - Manual (Page 88)

CFN Series System
11-2 03/07/03
7. Verify that the quantity displayed on the Hose 1 register matches the quantity (and price, if
applicable) recorded on the system printout.
8. Repeat Steps 2 through 7 for all hose outlets.
NOTE: Continue with Steps 9 through 13 only if you are using dispensers or dual hose
single motor suction pumps.
9. Using the test card/key, select two hose outlets of the same product type (that use the same
submersible pump).
10. Turn on both pump handles. Both hose outlets should reset and be able to dispense
product.
11. While dispensing product from one hose (A), allow the other hose (B) to time out.
12. When Hose B has timed out, try to dispense product from it by squeezing the nozzle. You
should not be able to dispense product from Hose B. If you can, verify that the dispensers
use solenoid valves rather than hydraulic valves, and re-check that particular pump's or
dispenser's wiring.
13. Repeat Steps 9 through 12 for all combinations of hose outlets of the same product type.
CHECKPOINT - POSTPAY PUMP ACTIVATION TEST (OPTIONAL)
For more information, see the CheckPoint Reference Manual.
1. Use the pump handle to turn on pump 1. CheckPoint beeps at set intervals and hose select
LED flashes red for pump 1 on CheckPoint.
2. On the CheckPoint, select pump 1 and push START.
3. Dispense some product from pump 1, then turn pump 1 off by using the pump handle.
4. Pay off sale (Press CASH, enter amount, ENTER). If cash drawer is present, it will open.
Close drawer.
5. Verify that the quantity displayed on the pump 1 register matches the quantity recorded on
the system printout (cash price, price level 1 or level 0 if no level 1 is used).
6. Repeat Steps 1 through 5 for all hose outlets.
CHECKPOINT - PREPAY PUMP ACTIVATION TEST (OPTIONAL WHEN
USING DUAL-STAGE SOLENOID VALVES)
1. Select Hose 1 on the CheckPoint by pushing the pump 1 key.
2. Select the prepay mode on the CheckPoint by pressing 1 0 0 PREPAY.