Mathey Dearman CNC Saddle Machine - Manual (Page 105)

CNC Saddle Machine Parts & Operating Manual 03-0117-MSA 03-0117-1SA 03-0117-2SA Ver 1.0
105
9. Set Home Button – This button will redefine the zero degree point of the ring gear, when pressed this
will override the value set during calibration.
10. Jog Clockwise Button – Pressing this button will cause the machine to rotate in the clockwise direction
in relation to the front of the machine. This direction is also in the positive domain of the clocking angle.
11. Warning Label – The purpose of this warning is to inform of the possibility that whenever a cut is
complete the drop side of the cut may fall and damage the machine or user if not properly secured. If
clocking is set to a position that starts on the lower half of the pipe then it will finish on the lower half of
the pipe whenever the drop piece has been disconnected.
12. Back Button – Go to the previous cut selection screen.
13. Next Button – Go to the next cut selection screen.