Mathey Dearman CNC Saddle Machine - Manual (Page 32)

CNC Saddle Machine Parts & Operating Manual 03-0117-MSA 03-0117-1SA 03-0117-2SA Ver 1.0
32
5.6 Final Prep
5.6.1 When ready to begin configuring a cut, twist the red E Stop Switch (Figure 6 Item 4) to power on the
Mathey CNC Saddle Machine. The red Power LED (Figure 6 Item 16) will illuminate on the Machine
Control Module indicating the machine is powered on. A blue communication LED (Figure 6 Item 17)
will illuminate if the USB cable is connected and the laptop is powered on. The blue LED indicates
the CNC Saddle Machine is communicating with the laptop computer and is ready to configure and
execute cuts once the MatheyCNC software is installed, activated, & launched.
5.6.2 At the Cut Configuration Screen go to the Settings menu in the bottom left hand corner.
(See Figure 5-13)
Figure 5-13 Cut Configuration Screen