Nevion Multicon MRP - Manual (Page 46)

Modular Routing Protocol - MRP Rev. L
nevion.com | 46
s pg
Status parameter group
x
6.9
si
Partial status (l, vt, sg, pg)
x
6.6
sspi
Status input signal presence
x x
6.6
sspo
Status output signal presence
x x
6.8
x l
Crosspoint take
x x x
7.1
x vl
Virtual crosspoint take
x
7.3
x s
Salvo take
x
7.4
x pg
Set parameter value
x
7.5
ld
Lock and protect crosspoint
x x
7.6
lr
Reset all locks and protections on a level
x
7.7
alarm
Server alarms
x x 5
8.1
alist
Alarm list
x x
8.2
event
Server events
x 6 x 7
8.4
sl
Status Locking – level x
8
x
6.2
rlist
Router list 9.2
plist
Router partition list 9.3
blist
Bus list 9.4
mlist
Module list 9.5
sin
List input configuration and status 9.6
sout
List output configuration and status 9.7
smonitor
Monitor status 9.8
partition
Partition router 9.9
in
Set input configuration 9.10
out
Set output configuration 9.11
monitor
Set monitor configuration 9.12
env
Set environment alarm limits 9.13
senv
List environment status 9.14
A server which is implementing this protocol must support all the commands in the
minimum column.
A control system which supports this protocol must not require any of the commands not in
the minimum column.
5 Command not implemented, status returned on changes
6 Command not implemented, status returned on changes
7 Command not implemented, status returned on changes
8 For backwards compatibility only, do not use for new implementations