QuickLabel Kiaro! - Manual (Page 152)

UW-5 Unwinder
136 Kiaro! User Guide
10 If you are using gap or reflective mark media, cut the media edge that will be fed
into the printer. If you are using continuous media, skip this step.
• If you are using gap media, cut the media between labels as illustrated by the
dashed red line below. The arrow indicates the direction of media feed into the
printer.
• If you are using reflective mark media, cut the media between labels, but
before the mark, as illustrated by the dashed red line below. The arrow
indicates the direction of media feed into the printer.
11 Turn the power switch [3] on the unwinder to the on position.