H3C Technologies H3C S12500-X Series Switches - Manual (Page 188)

178
<SwitchD> system-view
[SwitchD] acl ipv6 number 2005
[SwitchD-acl6-basic-2005] rule permit source ff0e::101 64
[SwitchD-acl6-basic-2005] quit
# Configure VLAN-interface 105 as a C-BSR and a C-RP, and set the hash mask length to 128 and
the priority of the C-BSR to 10.
[SwitchD] ipv6 pim
[SwitchD-pim6] c-bsr 4002::1 hash-length 128 priority 10
[SwitchD-pim6] c-rp 4002::1 group-policy 2005
[SwitchD-pim6] quit
# On Switch E, configure the service scope of RP advertisements, configure VLAN-interface 102 as
a C-BSR and a C-RP, and set the hash mask length to 128 and the priority of the C-BSR to 20.
<SwitchE> system-view
[SwitchE] acl ipv6 number 2005
[SwitchE-acl6-basic-2005] rule permit source ff0e::101 64
[SwitchE-acl6-basic-2005] quit
[SwitchE] ipv6 pim
[SwitchE-pim6] c-bsr 1003::2 hash-length 128 priority 20
[SwitchE-pim6] c-rp 1003::2 group-policy 2005
[SwitchE-pim6] quit
Verifying the configuration
# Display IPv6 PIM information on Switch A.
[SwitchA] display ipv6 pim interface
Interface NbrCnt HelloInt DR-Pri DR-Address
Vlan100 0 30 1 FE80::A01:201:1
(local)
Vlan101 1 30 1 FE80::A01:201:2
Vlan102 1 30 1 FE80::A01:201:3
# Display BSR information on Switch A.
[SwitchA] display ipv6 pim bsr-info
Scope: non-scoped
State: Accept Preferred
Bootstrap timer: 00:01:46
Elected BSR address: 1003::2
Priority: 20
Hash mask length: 128
Uptime: 00:04:22
# Display BSR information on Switch D.
[SwitchD] display ipv6 pim bsr-info
Scope: non-scoped
State: Candidate
Bootstrap timer: 00:01:45
Elected BSR address: 1003::2
Priority: 20
Hash mask length: 128
Uptime: 00:05:26
Candidate BSR address: 4002::1