Configuration procedure, Configuring a multicast group filter, Adjusting igmp performance – H3C Technologies H3C S12500-X Series Switches User Manual
Page 65: Configuring the rpf route selection rule
55
•
A static member interface does not respond to queries that the IGMP querier sends. When you
configure an interface as a static member or cancel this configuration on the interface, the interface
does not send any IGMP report or IGMP leave message without a request. This is because the
interface is not a real member of the multicast group or the multicast source and group.
Configuration procedure
To configure an interface as a static member interface:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A
3.
Configure the interface as a
static member interface.
igmp static-group group-address
[ source source-address ]
By default, an interface is not a
static member of any multicast
group or multicast source and
group.
Configuring a multicast group filter
To restrict the hosts on the network attached to an interface from joining certain multicast groups, you can
specify an ACL on the interface as a packet filter so that the interface maintains only the multicast groups
that match the criteria.
To configure a multicast group filter:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A
3.
Configure a multicast group
filter.
igmp group-policy acl-number
[ version-number ]
By default, no multicast group filter
is configured on any interface.
Hosts attached to an interface can
join any multicast group.
NOTE:
If you configure the interface as a static member interface for a multicast group or a multicast source and
group, this configuration is not effective for the multicast group or the multicast source and group.
Adjusting IGMP performance
Before adjusting IGMP performance, complete the following tasks:
•
Configure any unicast routing protocol so that all devices are interoperable at the network layer.
•
Configure basic IGMP functions.
- H3C S9800 Series Switches H3C S5560 Series Switches H3C S5130 Series Switches H3C S5120 Series Switches H3C S12500 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module