Gateway 6400 - Manual (Page 104)

Peripheral/adapter problems 95
Peripheral/adapter problems
The system does not recognize a SCSI device.
The system does not recognize an adapter card.
Probable cause Solution
The device needs to be
added as new hardware In the Control Panel window (Start | Settings |
Control Panel), double-click Add New
Hardware. Follow the on-screen instructions
for adding the device.
The SCSI ID may be invalid Assign an available SCSI ID to the device.
The SCSI chain is not
properly terminated Make sure the last device on the SCSI chain
is terminated.
The device cables are not
installed correctly Open the system and check all cables
between the controller and the device. Install
the cables correctly if necessary.
Probable cause Solution
The interrupt or I/O address
is set incorrectly Check the address configuration of the adapter
card and make sure that it does not conflict
with another card in the system.
The card was not configured
through the software Configure the card with the appropriate
software.
The card was not installed
correctly Make sure that the jumpers are configured
correctly, then reseat the card.
05032.book Page 95 Monday, July 10, 2000 11:43 AM