Replacing the power supply – Gateway 6400 User Manual
Page 64
Replacing the power supply
55
Replacing the power supply
To remove the power supply:
1
Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
2
Remove the left side cover panel. (See “Removing the side cover” on
page 18 and “Preventing static electricity discharge” on page 15.)
3
Lay the case on its right side, if possible.
4
Disconnect the power supply connectors from all internal devices
including the 3.5-inch diskette drive, the CD drive, and all hard drives.
5
Disconnect the main power supply connector to the system board by
pressing on the tab to release the connector, then gently pulling the
connector from the board.
6
Remove the cable supports securing the power supply cables to the
chassis.
05032.book Page 55 Monday, July 10, 2000 11:43 AM