Lynx Professional Grills 42" Free Standing Grill L42PSR-1 - Manual (Page 21)

1
burner eXTinguishes
loCATion
first determine if the problem
is being caused by location.
irst determine if the problem irst determine if the problem
If the grill is subject to high
is being caused by location. is being caused by location.
winds, reposition it to provide
some protection.
chEcK ThE fLAmE
check the gas supply and
flame characteristics.
heck the gas supply and heck the gas supply and
(See
indeX: “flame, Correct size”)
BURnERS SEATEd
check to ensure that the
burners are correctly posi-
tioned in the grill.
burners are correctly posi burners are correctly posi
(See IndEX:
“burner Placement” for further
tioned in the grill. tioned in the grill.
details.)
Correctly-installed burners
should be seated firmly and
Correctly-installed burners Correctly-installed burners
level with no side-to-side
movement.
burner eXTinguishes
only when seT To
“low”
The valves on the grill feature
an adjustable low setting.
fluctuations in gas pressure,
gas conversion and even in
luctuations in gas pressure, luctuations in gas pressure,
the quality of the gas itself
gas conversion and even in gas conversion and even in
may affect burner perfor
the quality of the gas itself the quality of the gas itself
- may affect burner perfor may affect burner perfor
mance at the “
may affect burner perfor may affect burner perfor
low
may affect burner perfor may affect burner perfor
” setting.
It could be either too high or
too low. (see indeX: “burner
Adjustment” for further details.)
roTisserie won’T
lighT
follow the same procedure as
described for the grill burners
ollow the same procedure as ollow the same procedure as
to diagnose problems with the
rotisserie burner.
to diagnose problems with the to diagnose problems with the
BE cAREfUL! The rotisserie
burner flame may be hard to
see in bright sunny conditions.
►
►
►
roTisserie lighTs
buT goes ouT As
soon As ConTrol is
RELEASEd
chEcK
TherMoCouPle
The control knob must be
held in for 30 to 60 seconds
after ignition for the rotis-
serie burner to stay lit. (See
indeX: “lighting the rotisserie”
for further details.)
If the burner will not stay lit
when you release the control
knob, re-light it and hold the
control knob in for at least
knob, re-light it and hold the knob, re-light it and hold the
60 seconds to allow the ther-
mocouple to heat up.
If, after holding the control
knob in for at least 60
If, after holding the control If, after holding the control
seconds, the burner still will
not stay lit when releasing
the control knob, call for
not stay lit when releasing not stay lit when releasing
service.
(see indeX: “obtaining service
from lynx” for further details.) ll
lighTs won’T lighT
CheCK Power CK CK
Ensure that the grill is
connected to a live Ac
power source and check for
rotisserie motor operation.
reseT TrAnsforMer
disconnect power from the
grill and wait 5 minutes for
isconnect power from the isconnect power from the
the transformer to cool down
grill and wait 5 minutes for grill and wait 5 minutes for
and reset. Then reconnect
power. If, after resetting the
transformer and replacing
power. If, after resetting the power. If, after resetting the
bulbs, you still do not have
transformer and replacing transformer and replacing
power, call for service.
bulbs, you still do not have bulbs, you still do not have
rePlACe The bulb
Replacement bulbs are
halogen, 12 volt, 10
Replacement bulbs are Replacement bulbs are
w
max, T type with a
g4 bi-pin base.
type with a type with a
►
►
►
►
The glass cover is held in
place by two spring tension
tabs. You may have to loosen
place by two spring tension place by two spring tension
the screw to remove the lens.
Avoid touching the glass of a
new bulb. halogen bulbs are
very sensitive to the oils found
alogen bulbs are alogen bulbs are
in human skin. Touching the
bulbs may shorten their life.
in human skin. Touching the in human skin. Touching the
the socket without twisting.
The 27” and 30”grills each
have one halogen light fixture;
The 27” and 30”grills each The 27” and 30”grills each
all other grills have two light
fixtures.
all other grills have two light all other grills have two light
hold the bulb using a paper
towel or other cloth and
old the bulb using a paper old the bulb using a paper
gently press it straight into the
socket. The glass cover should
gently press it straight into the gently press it straight into the
be gently snapped back into
place.
be gently snapped back into be gently snapped back into
Pull on
sPrIng
tabs to
release
lIght
Cover
Pull on
sPrIng
tabs to
release
lIght
Cover