Lexicon SDP-40 - Manual (Page 32)

2-16
Basic Operation
JBL
MODE BUTTONS
This type of listening mode selection occurs each time the Mode
Up and Down buttons are pressed on the front panel, or the MODE
+/- buttons are pressed on the remote control. This type of mode
scrolling allows auditioning of all listening modes available for the
current input type.
Pressing the Mode Up/MODE + button selects the previous
listening mode on the list. Pressing the Mode Down/MODE -
button selects the next listening mode on the list. 2-channel
listening modes are listed on page 3-10. Dolby Digital and dts(-ES)
listening modes are listed on page 3-11. These lists are not visible
on the on-screen and front panel displays during scrolling.
Note:
When the input type changes, the unit will
automatically revert to the default listening modes
selected in the INPUT SETUP menu. If USE LAST is
selected in the INPUT SETUP menu when the input
format changes, the unit will revert to the listening
mode that was last used for the input type.
UNDERSTANDING LISTENING MODE SELECTION
There are three different methods of selecting listening modes in
the Main Zone:
• The INPUT SETUP Menu
• The Mode up and down buttons on the front panel or the
MODE +/- buttons on the remote control
• The Mode Family Selection Buttons on the remote control:
Listening mode selection only applies to the Main Zone.
INPUT SETUP MENU
This type of listening mode selection occurs each time a listening
mode is changed in the INPUT SETUP menu, and each time an
input is selected using the input selection buttons on the front
panel or the remote control.
The INPUT SETUP menu can be used to select a preferred
2-channel, Dolby Digital, and dts(-ES) listening mode for each
input. When an input type is recognized, the unit automatically
defaults to the appropriate listening mode. (See page 3-3 for more
information about the INPUT SETUP menu. See Section 5 for more
information about listening modes.)
For example, the 2-CH parameter on the INPUT SETUP menu is set
to LOGIC7 FILM and the DOLBY D parameter is set to 5.1 LOGIC7
MUSIC. When the input type changes from 2-channel to Dolby
Digital, the listening mode will automatically change from LOGIC7
FILM to 5.1 LOGIC7 MUSIC.
MUSIC