Lexicon SDP-40 - Manual (Page 38)

DVD1 INPUT SETUP
NAME DVD1
DIGITAL IN COAX-1
ANALOG IN NONE
ANLG IN LVL AUTO
VIDEO IN S-VIDEO-1
COMPONENT IN 1
2-CH L7 FILM
D 5.1 L7 FILM
dts L7 FILM
MAIN ADVANCED
ZONE2 ADVANCED
RECORD ADVANCED
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
3-5
The SETUP Menu
SDP-40
DIGITAL IN
Selecting DIGITAL IN accesses the DIGITAL IN menu, which can be
used to assign the digital connector for the selected input. Digital
input selection will take precedence over analog input selection
unless:
• No valid digital input signal is present.
• The DIGITAL IN parameter is set to NONE.
• The INPUT SELECT parameter on the MAIN ADV menu is set to
ANALOG (see page 3-13).
SETUP INPUTS DVD1 DIGITAL IN
DVD1 DIGITAL IN
COAX-1
COAX-2
COAX-3
COAX-4
COAX-5
COAX-6
OPTICAL-1
OPTICAL-2
OPTICAL-3
OPTICAL-4
OPTICAL-5
OPTICAL-6
AES/EBU
NONE
INPUT SETUP
DVD1
DVD2
LD
TV
SAT
VCR
CD
PVR
GAME
TAPE
TUNER
AUX
SETUP
INPUTS
SPEAKERS
REAR PANEL CONFIG
DISPLAYS
VOLUME CONTROLS
TRIGGERS
LOCK OPTIONS
DVD1 is used as an example in this illustration, and will continue to be used as an example
throughout this section. Whenever “DVD1” appears as a step in a menu path, any other input
may be substituted.
Note:
When DIGITAL IN is set to NONE, the INPUT SELECT
parameter on the MAIN ADV menu is automatically
set to ANALOG (see page 3-13).
When a connector is selected for both the DIGITAL IN
and ANALOG IN parameters, all INPUT SELECT
parameters will automatically be set to AUTO. The
INPUT SELECT parameters are located on the MAIN
ADV, ZONE 2 ADV, and REC ADV menus (see pages
#-# to #-#).