I-View AnyNet-0401Mini Embedded NVR - Manual (Page 49)

49
Step 3.
Type the SMS message.
Step 4.
Click “Save” button to save your pending entry. That entry will be listed at the
bottom section of this window.
Step 5.
Repeat steps 2 through 5 to add another SMS message notification entry.
You must use an approved 3G Modem for sending SMS message to mobile phone.
Shift PTZ position: Upon motion detection, the
PTZ camera can automatically move to the
aiming position(s) of one or more or whatever
the preset position(s) the user has defined. Please
define the preset position from “Video Control
Panel” before setup. For more information about
PTZ installation, please refer to the RS-485
control card (e.g. NC-3213USB) user manual.
Step 1.
Select a PTZ camera from “Camera”
drop-down menu in the “Move to preset
position(s) when triggered” section at
the top.
Step 2.
Select a preset position from “Aim to” drop-down menu in the “Move to preset
position when triggered” section at the top.
Step 3.
Click “Save” button on the right to add your new entry to the list.
Step 4.
Repeat step 1 through 3 to add other PTZ cameras to move upon motion detection.
For “Return to preset position(s) when stop trigger” setup, please follow the same procedures
with the “Move to preset position(s) when triggered” section.
Alarm zones setup: This function can be enabled when the public address server connected to
the NVR. The public address server will announce to the camera site via group(s) or zone(s)
automatically when the NVR is triggered. Follow up the steps shown as below to setup
announcement area: