HP StorageWorks 1000 Modular Smart Array User Manual
Page 47
Controller Display Messages
47
100 VOLUME #<n>
STATE OK
Informational
The configured volume has
returned to its normal
operating state. This
typically occurs after a
rebuild operation has
completed.
101 VOLUME #<n>
STATE FAILED
Error
The configured volume has
been failed because too
many SCSI drives that it is
composed of have failed
exceeding the fault
tolerance level. The data on
the configured volume is no
longer available.
102 VOLUME #<n>
STATE INTERIM
RECOVERY
Informational
The array controller has
failed one or more SCSI
drives that the configured
volume is composed of but
no data loss has occurred
because fault tolerance is
allowing the data to be
recovered.
The failed drives should be
replaced as soon as
possible following the
guidelines in the
Recovering from Hard
Drive Failure
(Appendix E)
section in this guide.
103 VOLUME #<n>
STATE REBUILDING
Informational
The configured volume is
rebuilding data on a SCSI
drive that replaced a
previously failed drive.
104 VOLUME #<n>
STATE DISABLED
Error
The configured volume has
been disabled because too
many of the SCSI drives
that it is composed of are
missing.
Power off the MSA1000
and then all attached
storage enclosures. Unplug
and reinsert all SCSI drives
insuring they are fully
seated in their bays. Check
the cables connecting the
MSA1000 to any attached
storage enclosures. Power
on the attached storage
enclosures and then the
MSA1000.
105 VOLUME #<n>
STATE EXPANSION
ACTIVE
Informational
The configured volume is
currently performing a
volume expansion
operation.
Table 3: LCD Message Descriptions
Message
Type
Description
Action