Videoswitch Vi605 - Manual (Page 39)

Digital Recorder
35
[<][>] Move cursor to select hour of day
[^][v] Select whether alarm is active
A block indicates that the alarm is active, a dash that is it disabled.
Enable Alarms all day
This menu option allows some or all cameras to have their alarms enabled all day,
irrespective of the Weekday and Weekend alarm time settings.
[<][>] Move cursor to select camera
[^][v] Select whether alarm is always active
Activity Detection
Activity detection may be enabled on any of the cameras. If movement is detected, a
number of actions may occur, including:
Add event to event log
Send an Email
Call an alarm center
Change record rate
Change cameras that are recorded
Pull-up alarmed camera onto a monitor
Activity Zones
Activity zones may be selected for each camera to specify what area the image is to be
monitor for movement.
[OK] Select/deselect zone at cursor
[<][>][^][v] Move cursor and select/deselect
[TAG] All zones on/off, default sens/pix
A "+" indicates that a zone is selected.
If activity is detected, this will become solid block.
As well as specifying the activity zones, you also need to specify the sensitivity and the
number of pixels that need to be simultaneously active.
Enter two digits, [0..9] for sensitive and [0..9] for number of active pixels.
A higher sensitivity setting makes the unit more sensitive to activity.
The higher the pixel count, the less sensitive the unit will be to spurious triggering.
Activity Timers
The alarms may be programmed to be operative only during particular hours of the day.
These hours may be different for weekdays and weekends.
Weekday Activity Times
Specify during which hours of the weekend the activity detection is active
[<][>] Move cursor to select hour of day
[^][v] Select whether alarm is active