Videoswitch Vi605 - Manual (Page 44)

Digital Recorder
40
9.5 Domes
The following section only applies to DVR models that support telemetry controlled domes
or pan and tilt heads. DVRs that do not directly support dome control can by controlled
directly by Videoswitch Joystick keyboards as they have the dome protocols built in.
Protocol set-up
Videoswitch DVRS that have built-in telemetry dome control provide two independent
outputs. Domes with different protocols may be connected to each.
DOMES-1 protocol (twisted pair)
Specify here which protocol is to be applied to all domes connected to the DOMES-1 output
[^][v] Select protocol
DOMES-2 protocol (twisted pair)
Specify here which protocol is to be applied to all domes connected to the DOMES-2 output
[^][v] Select protocol
Up-the-coax protocol
Specify here which up-the-coax protocol is to be used.
Type of control for each camera
Each dome camera needs to be assigned to either: DOMES-1 output
DOMES-2 output
Co-ax telemetry control
Control via an external Vi-K2 keyboard
Dwell/Speed/Tour Settings
When setting tours or preset from within this menu, the following parameters may need to
be set. All domes are different so these do not apply to all domes.
Dwell Time
This specifies the dwell time within a tour.
Speed
This specifies the speed at which the dome moves to a preset.
Include preset in tour
This specifies whether presets are to be included in a tour as they are programmed. This
only applies to types of dome that use this method.
Preset Programming
Dome preset positions may be set here. Note that with some times of dome, the presets
have to be set via the dome menu.
Go to Preset
This may be used to check preset positions. Some types of dome require that you call up a
preset prior to setting its new position.
[^][v] Select preset