Videoswitch Vi605 - Manual (Page 53)

Digital Recorder
49
However, if colour saturation is reduced due to long cable runs, it can be boosted here.
Termination
You can specify here whether individual camera inputs are terminated (with 75 ohms).
All camera inputs should be terminated unless they are looped through to other equipment
that terminates them.
[<][>] Select camera input
[^][v] Turn termination on or off
[TAG] Turn termination on or off for all cameras
Record Audio
Select here whether you wish to record audio or not.
Altering this setting may affect video images that have already been recorded. It is therefore
recommended that it is set either on or off during installation and not changed during normal
operation.
Incident Filename
Incidents are given numeric filenames that automatically increment each time a CD is
written to (burnt). This menu option allows the starting numeric filename to be specified.
[0..9] Enter a numeric filename
Restore Factory Defaults
If you press [OK] in this menu option, you will reset all menus options back to their factory
defaults.
This can be very useful and is recommended after major software updates.
However is can undo a lot of work if significant customisation of the configuration has been
undertaken.
Get Config from CD
When incidents are written to a CD, the configuration of the unit is also written.
This menu option allows a configuration to be retrieved from CD. This can be very useful
when multiple sites need the same configuration.
Getting configuration from CD should only be performed on a DVR which is the same type
and has the same software revision as the unit that created the CD.
Erase Hard Drive(s)
These menu options reset the drives to a clean starting point where no images, events of
audio is retrievable.
Note that the erase operation actually only removes indexes, so the actual data will still be
on the drives, although not accessible except with specialist equipment.
Erase Hard Drive 1
Press [OK] to perform a disc erase of hard drive 1.
Erase Hard Drive 2
Press [OK] to perform a disc erase of hard drive 2 (only available if the DVR has multiple
drives).