Dillon EDXtreme (Red) - Manual (Page 18)

EDXtreme User Instructions 17
2.5 Power On and Annunciators
When the EDX powers up you will see a display similar to the example shown on the
left in
Figure 2.8 .
Figure 2.8 Initial Displays
The display sample above shows several symbols you may see on your display but
usually not all at the same time.
Press the Arrow key, , to move between the two displays shown in Figure 2.8 .
Force Force lbf lbf
0 0
Mode Config Setup Print Clear Units
Arrow key
press
ESC key
press
Log
Depending on permission settings and/or revision of firmware, various soft keys may
be in a different location or not visible.
Force
Indicates that the display is showing live force measurement at the moment. Will show
Peak when viewing Peak Mode.
lbf
Current unit of measure is lbf in this example. May also be kgf, N, or up to 2 other
custom units.
~
Motion symbol. This appears when the force is in motion. This symbol disappears
when motion ceases.
Battery annunciator. This shows approximate remaining battery life.
Capture of a new peak value. This annunciator will remain lit for a few seconds.
lbf and kgf are units of force, not weight. See Config--Units on page 39 for more
information.