Dillon EDXtreme (Red) - Manual (Page 46)

EDXtreme User Instructions 45
Blite Use this to adjust the intensity and mode of the optional
backlight. Intensity adjusts the brightness of the backlight. Using
Mode you can set the backlight to OFF, ON, or TIMER. If you
select TIMER, the backlight will shut off after a configurable
period of time (in seconds), without a keystroke. You are also
given the option of choosing if motion will reset the backlight
timer to start counting again.
About Press this soft key to see the following information:
l Communicator Serial Number
l Firmware part number
l Revision level of software
Press ESC repeatedly to return to normal operation. If you have made changes you will
be prompted to save the changes. Press the Yes soft key to save the changes and
return to normal operation. Press the No soft key to disregard any changes made and
return to normal operation. Press the Cancel soft key to return to the Setup menu
screen.
Test Lets you test the following items:
Batt Press this to check the battery condition. Display shows voltage
condition of the batteries.
Disp Press this to perform a display test. Press any key to stop the
test.
Keys Press this key to test individual key function. Press ESC to stop
the test.
Comm Press this key to perform LOOP/NOLOOP tests on CELL. Press
ESC to return to Test soft key display. CELL must be enabled
and configured to RS232 in Config menu to test.
This completes the Setup menu description.
Backlight intensity shortcut
Press Arrow key and F4 simultaneously to increase intensity. Press Arrow key and
F3 simultaneously to decrease intensity.